Removal - TM-55-1930-208-240221

TM 55-1930-208-24

3-53. SHAFT ASSEMBLY - Continued.

a. Removal. (Refer to figure 3-110).

(1) Remove four nuts (1), four screws (2), and clamp (3).

(2) Remove eight nuts (4), sixteen flat washers (5), and eight screws (6). Remove eigh screws (7) and two

brackets (8).

(3) Remove five screws (9), five flat washers (10), and guard (11).

(4) Remove three screws (12), three thumbscrews (13), and guard (14).

(5) Remove twenty-four nuts (15), twenty-four washers (16), and twenty-four bolts (17) securing upper and

lower companion flanges (18) to flange yokes (19).

(6) Refer to paragraph 3-52 and remove speed reducer.

(7) Remove eight screws (20) securing four dust caps (21) and four lock straps (22) to the upper flange yoke

and slip yoke.

(8) Remove the dust caps and lock straps from lower flange yoke and tube yoke in the same manner.

(9) Remove universal joints (23).

(10) Separate tube yoke (24) and pull remaining shaft components up through stuffing box.

b. Disassembly.

(1) Refer to figure 3-110 and loosen dust cap (25) and separate slip yoke (26) from slip tube (27).

(2) Remove eight bolts (28) and remove stuffing box (29) and gasket (30) from insert plate (31).

c. Cleaning.

WARNING

Do not breathe cleaning solvent P-D-680 vapors for long periods of time or use

solvent near open flames. To avoid illness, explosion, or fire, only use solvent

in well-ventilated areas away from open flames.

(1) Clean all parts with cleaning solvent (item 4, Appendix C).

(2) Allow all parts to dry.

3-184