SHAFT ASSEMBLY.

TM 55-1930-208-24

(5) Refer to figure 3-108 and pack the spacers between and around the grid (4) with as much lubricant as

possible and wipe off excess flush with top of grid. Position seals (6) on hubs (5) to line up with grooves in

cover. Position gaskets (3) on flange of lower cover half and assemble covers (2) so that the match marks

are on the same side.

(6) Secure cover halves (2) with fasteners (1) and torque fasteners to 200 lb-in (22.75 Nm).

(7) Refer to figure 3-107 and install cover (2) and secure with four bolts (1).

3-53. SHAFT ASSEMBLY.

This task covers:

a. Removal

b. Disassembly

c. Cleaning

d. Inspection

e. Repair

f. Reassembly

g. Installation

INITIAL SET-UP:

Tools Required:

Tool Kit, General Mechanic's (Item 1, Appendix B)

Materials Required:

Gasket P/N HH-P-151

Joint P/N 5-281X

Solvent, Cleaning (Item 4, Appendix C)

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

3-183