Reassembly - Continued. - TM-55-1930-208-240216

TM 55-1930-208-24

(23) Refer to figure 3-103. Coat housing cover base with permatex (item 19, Appendix C). Install two eye bolts

to cover (43). Attach a sling to eye bolts. Use a lifting device capable of lifting 150 lbs (68.10 Kg) and

install cover (43). Secure cover with thirteen lockwashers (42) and thirteen bolts (41). Torque bolts to

1100 lb-in (125.12 Nm).

(24) Install oil distributor (40) and secure with six lockwashers (39) and six bolts (38). Torque bolts to 255 lb-in

(29.02 Nm).

(25) Install dipstick (37) and breather (36).

(26) Install shim gasket (35) and cover (34) and secure with eight lockwashers (33) and eight bolts (32). Torque

bolts to 640 lb-in (62.80 Nm).

(27) Install shim gasket (31) and cover (30) and secure with eight lockwashers (29) and eight bolts (28). Torque

bolts to 255 lb-in (29.02 Nm).

(28) Install shim gasket (27) and cover (26) and secure with eight lockwashers (25) and eight bolts (24). Torque

bolts to 255 lb-in (29.02 Nm).

(29) Install key (19) and fan (7) on shaft (16).

Install baffle (8) and cover (6).

Secure cover with two

lockwashers (5) and eight screws (4).

(30) Attach a sling to the four lifting eyes on the speed reducer. Attach a lifting device, capable of lifting 750 lbs

(340.50 Kg) to sling.

(31) Slowly raise speed reducer until bottom shaft clears bottom of machinery house door. Move speed

reducer into machinery house. Rotate speed reducer and lower it on the mounting base, making sure the

mounting holes are aligned.

(32) Install four bolts (3), four lockwashers (2), and four nuts (1).

(33) Refer to TM 55-1930-208-10, paragraph 3-1 and fill speed reducer with oil.

(34) Install shaft assembly per paragraph 3-53.

(35) Install coupling per paragraph 3-52.

3-179