Figure 3-92. Flywheel Housing, Removal.

TM 55-1930-208-24

3-45. FLYWHEEL HOUSING - Continued.

a. Removal. (Refer to figure 3-92).

(1) Remove two bolts securing lifting bracket (1) to cylinder head.

(2) Remove twelve bolts (2) from inside housing bell.

(3) Remove twelve bolts (3) from around upper portion of housing (6).

(4) Remove two bolts (4) that secure the housing from the front of the rear end plate.

(5) Install four pilot studs (5) to block.

(6) Attach chain hoist to lifter bracket.

(7) Strike the housing on the front face with a soft hammer on both sides to work the housing off the dowels and

away from the cylinder block.

(8) Remove and discard gasket.

Figure 3-92. Flywheel Housing, Removal.

b. Cleaning.

(1) Clean housing with clean fuel oil (item 9, Appendix C). Be sure to remove all traces of gasket from both the

housing and the block mating surfaces.

(2) Wipe off excess oil and dry.

Inspection.

(1) Inspect for cracks and other damage.

(2) Inspect for damaged or missing mounting hardware.

3-156