Cleaning. - TM-55-1930-208-240159

TM 55-1930-208-24

3-34. COVER, ROCKER ARM - Continued.

b. Cleaning.

(1) Remove all buildup of dirt, grease, etc. by wiping with a clean, soft cloth (item 23, Appendix C).

WARNING

Do not breathe cleaning solvent P-D-680 vapors for long periods of time or use solvent near open flames.

To avoid illness, explosion, or fire, only use solvent in well-ventilated areas away from open flames.

(2) Clean using a clean, soft cloth (item 23, Appendix C) or a medium bristle brush (item 14, Appendix C) and

cleaning solvent (item 4, Appendix C).

(3) Allow to dry.

c. Inspection.

(1) Inspect for cracks, dents, and signs of obvious damage.

(2) Inspect for missing or damaged hardware.

d. Installation.

(1) Refer to figure 3-69 and install seal (12), cover (11), retainer (10), disk (9), retainer (8), and secure with

screw (7).

(2) Install new gasket (6) and cover assembly (5) on cylinder head.

(3) Install two isolators (4), two flat washers (3), and two bolts (2). Torque bolts (2) to 15-20 lb-ft (20-27 Nm).

3-122