Reassembly. - TM-55-1930-208-240095

TM 55-1930-208-24

3-18.

INTAKE, AIR CLEANER ASSEMBLY - Continued.

f. Reassembly.

(1) Install two pipe plugs (23) and air cleaner mounting tube (22) in the housing.

(2) Place the valve (11) and spring (10) in position in the housing and lip shaft (12) in place. Then,

install two pins (9) which retain the valve to the shaft.

(3) Lubricate with engine oil (item 8, Appendix C) and install new seal rings (8 and 13) at ends of the

shaft.

(4) Install the lever control cam (21) and lever handle (20).

(5) Install washer (7) and pin (6) at the other end of the shaft.

(6) Assemble bushing (19) and spring (18) on latch (17). Then, slip the attaching screw (14) through

the lockwasher (15), flat washer (16), and latch and bushing. Attach the latch assembly to the

housing and tighten the screw.

g. Installation.

(1) Before attaching the air intake assembly to the blower, place a steel straight-edge lengthwise on

the face of the housing bolting flange and close the valve against the straight-edge. The finished

pads at each end of the valve must be flush against the straight-edge when it is moved from top

to bottom of the intake housing flange.

(2) Mount air intake housing (3) together with striker plate (5) and striker plate gasket (4) on the

blower with four lockwashers (2) and four screws (1). Tighten the screws to 16-20 lb-ft (22-27

Nm).

(3) Connect the air shutoff cable (paragraph 3-6). Start and run the engine at idle speed and no

load. Trip the air shutdown. If engine does not stop, check for air leakage between the valve

and the striker plate. If necessary, reposition the valve.

(4) Connect the ether starting aid (paragraph 3-23, TM 55-1930-208-10) and install the air cleaner

(paragraph 3-15, TM 55-1930-208-10).

3-58