|
|
![]() TM 55-1930-208-24
(5) Position spring (16) in barrel assembly (13). Using retaining ring pliers, install retaining ring (15). Install
pistons (14) in barrel assembly (13).
(6) Line up splines and install barrel assembly (13) on shaft (21).
(7) Position port plate (12) on housing (22) and secure with eight lockwashers (11) and eight screws (10).
Tighten screws alternately and pull port plate (12) evenly. Torque screws to 150 in-lbs (16.94 Nm).
(8) Install key (9) and starting drive (8) on shaft (21). Tighten screw (7).
(9) Install plate (6) and secure with two screws (5).
(10) Install flange (4) and housing (3) and secure with four lockwashers (2) and four screws (1).
3-12. HYDRAULIC PUMP.
This task covers:
a. Disassembly
b. Cleaning
c. Inspection
d. Repair
e. Reassembly
INITIAL SET-UP:
Tools Required:
Tool Kit, General Mechanic's (Item 1, Appendix B)
Materials Required:
Gasket P/N GA1129-1
Gasket P/N GA1129-2
Gasket P/N GA1129-4
Gasket P/N GA1129-5
Gasket P/N GA1129-7
Gasket P/N GA202082
Ring P/N RG1138
Ring P/N RG100157
Seal, Oil P/N SE100082
Solvent, Cleaning (Item 4, Appendix C)
Washer, Lock P/N WA5-10CA
Washer, Lock P/N WA6-10CA
Equipment Conditions:
Engine shut down (paragraph 2-11, TM 55-1930-208-10).
Hydraulic pump removed (paragraph 3-12, TM 55-1930-208-10).
3-23
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |