 |
|||
|
|
|||
|
Page Title:
Table 2-2. Operator/Crew Preventative Maintenance Checks and Services (cont) |
|
||
| ||||||||||
|
|
 TM 55-1915-200-10
B
Table 2-2. Operator/Crew Preventative Maintenance Checks and Services
EQUIPMENT NOT READY/AVAILABLE
- BEFORE D - DURING A - AFTER W - WEEKLY M - MONTHLY Q - QUARTERLY S/A SEMI ANNUALLY AN - ANNUALLY
IF
T/A - TRIENNIALLY
ITEM
B
D
AWM
Q S/A AN T/A
ITEMS TO BE INSPECTED
CHECK FOR
ACTION
PMC
NMC
NUMBER
Class III leaks
X
Oil and Cooling Systems
Conduct visual inspection for oil and cooling
Correct all oil water leaks,
document and report
system leaks. Direct particular attention to all
discrepancies/damage/
connections and sealing joints. (Refer to systems
Class III leakage to
piping diagrams, Chapter 2, Section III, Operation
engineer on watch.
Under Usual Conditions, Figures 2-104 and 2-
X
X
Conduct visual inspection for water leaks. Direct
Class III leaks
Correct all water leaks or
32
Potable Water System
particular attention to all connections and sealing
document and report
joints. (Refer to systems piping diagrams,
discrepancies/damage/Clas
Chapter 2, Section III, Operation Under Usual
s III leakage to engineer on
watch.
Conditions Figure 2-113). Check and clean supply
line strainer.
WARNING
Open the ventilators to ensure hull compartments
and engine room are clear of fuel fumes. Operate
the blowers for at least 5 minutes before starting
the engine.
X
X
X
Inspect engines, generators, fuel injection pumps Correct all defects.
33
Engine Accessories and
and cooling pumps for loose or damaged
Connections
connections.
X
Throttle control
Check the engine and generator for debris, foreign Remove foreign debris.
34
Generator Set Engine,
inoperative
objects and loose or broken fittings. Refer to TM Repair all loose
250 kW
55-1915-203-24.
connections and broken
fittings.
X
Block Heater
Check block heater for proper operation.
X
X
Oil Level
Check engine oil level. Ensure the level on the
Add oil as necessary.
Low oil level
dipstick is between the add and full marks on the
stopped side of the dipstick. Refer to TM 55-1915-
203-24.
Add coolant as necessary.
X
Cooling System
Check coolant level. Ensure coolant level in
expansion tank is at the full mark in overhead
sight glass.
X
Fuel System
Inspect fuel system for leaks. Check water
Repair leaks.
Class III leaks.
separator trap.
LSV PMCS
Change 12
2-266
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals