|
|
![]() TM 55-1905-223-24-7
h. Remove nonmetallic hose (10) from pressure vessel assembly by loosening hose clamp at that end.
i.
Remove four machine screws (12), flat washers (13), lockwashers (14), and plain hexagon nuts (15) securing
brine manifold (4) to main frame assembly.
j.
Remove brine manifold.
REPLACEMENT
a. Position brine manifold assembly in watermaker main frame assembly mounting position.
NOTE
Contact Intermediate Direct Support maintenance level to connect the fol-
lowing items after installation (steps b through i).
b. Secure brine manifold (4) with four plain hexagon nuts (15), lockwashers (14), flat washers (13), and machine
screws (12).
c.
Connect nonmetallic hose (10) with hose clamp on pressure vessel assembly and secure hose clamp.
d. Connect nonmetallic hose (18) with hose clamp on solenoid valve assembly and secure with hose clamp.
e. Connect nonmetallic hose (20) with hose clamp on solenoid valve assembly and secure with hose clamp.
f.
Connect nonmetallic hose (22) with hose clamp on micron filter assembly air bleedoff connection and secure with
hose clamp.
g. Connect nonmetallic hose (2) with hose clamp to cleaning valve assembly and secure with hose clamp.
h. Connect nonmetallic hose (24) with hose clamp on brine flowmeter assembly and secure with hose clamp.
i.
Connect salinity probe (11) wiring to water quality monitor terminals 4 and 5. Remove tags.
j.
Open appropriate inlet feedwater gate valve (2, FIGURE 2-30, Sheet 1).
k.
Start up watermaker. Refer to TM 55-1905-223-10.
1. Observe brine manifold assembly for leaks. Repair as necessary.
m. Remove "Out of Service - Do Not Operate" tag.
2-102
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |