Chapter 3. INTERMEDIATE DIRECT SUPPORT MAINTENANCE INSTRUCTIONS

TM 55-1905-223-24-17

CHAPTER 3

INTERMEDIATE DIRECT SUPPORT MAINTENANCE INSTRUCTIONS

Page

Section I.

Repair Parts, Special Tools; Test, Measurement, and

Diagnostic Equipment (TMDE); and Support Equipment ......................................

Section II.

Service Upon Receipt ..........................................................................................

Section III.

Intermediate Direct Support Preventive Maintenance

Checks and Services (PMCS)..............................................................................

Section IV.

Intermediate Direct Support Troubleshooting .......................................................

Section V.

Intermediate Direct Support Maintenance Procedures .........................................

Section VI.

Preparation for Storage or Shipment....................................................................

SECTION I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,

AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

3-1. Common Tools and Equipment . For authorized common tools and equipment, refer to the Modified

Table of Organization and Equipment (MTOE) applicable to your organization.

3-2. Special Tools, TMDE, and Support Equipment . Special tools; test, measurement, and diagnostic

equipment; and support equipment requirements-are listed and illustrated in the Repair Parts and Special Tools

List (RPSTL), TM 55-1905-223-24P1. These items are also listed in the Maintenance Allocation Chart (MAC),

Appendix B of this manual.

3-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),

TM 55-1905-223-24P1.

SECTION II. SERVICE UPON RECEIPT

3-4. Checking Unpacked Equipment.

a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,

report the damage in accordance with the instructions of DA Pam 738-750.

b. Check the equipment against the packing slip to see if the shipment is complete. Report all

discrepancies in accordance with the instructions of DA Pam 738-750.

Check to see whether the equipment has been modified.

3-1