|
|
TM55-1730-228-13&P
4-15.
STABILIZER CYLINDERS - REPAIR (Continued)
4-15
b. INSPECTION:
(1) Clean all parts with cleaning solvent and dry with a lint-free cloth.
(2) Inspect moving parts, especially the rod and tube, for evidence of wear, burrs, nicks, chips,
scoring and other damage.
(3) Replace damaged parts with new parts.
c. ASSEMBLY:
NOTE
Lubricate all seals and preformed packings with hydraulic fluid prior to installation of parts and
final assembly.
(1) Install tube seal (17) on end cap (3).
(2) Install tube seal (16) on end cap (4).
(3) Install rod seal (14) and backup washer (15) in end cap (4).
(4) Install rod wiper (13) in end cap (4) and lubricate with clean hydraulic oil.
(5) Install end cap (4) on rod (7).
(6) Install piston seals (12) on piston (6).
(7) Position piston assembly (6) on rod (7) and secure with nut (11).
(8) Screw rod eye (10) on rod (7).
(9) Install capscrew (9) and nut (8) on rod eye (10).
(10) Slide piston and rod assembly into tube (5).
(11) Install end cap (3) on cylinder tube (5).
(12) Install four tie rods (2) on end caps (3) and (4).
(13) Install tie rod nuts (1) on tie rods (2).
(14) Plug cylinder ports to prevent foreign matter from entering.
END OF TASK
4-55
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |