Figure 4-17. Stabilizer Cylinder Assembly (Sheet 2 of 2) .

TM55-1730-228-13&P

4-15.

STABILIZER CYLINDERS - REPAIR (Continu ed)

4-15

Figure 4-17 .

Stabilizer Cylinder Assembly (Sheet 2 of 2) .

DISASSEMBLY:

NOTE

Scribe mark the end caps and tube for correct alinement during assembly.

(1) Remove four tie rod nuts (1, Figure 4-17) from four tie rods (2).

(2) Remove four tie rods (2) from end caps (3) and (4).

(3) Remove end cap (3) from cylinder tube (5).

(4) Slide piston (6) and rod assembly (7) out of tube (5).

NOTE

End cap (4) will come off with piston.

(5) Remove nut (8) and capscrew (9). Unscrew rod eye (10) from rod (7).

(6) Remove nut (11) from rod (7) and remove piston (6).

(7) Remove piston seals (12) from piston (6).

(8) Slide rod (7) out of end cap (4).

(9) Remove rod wiper (13) from end cap (4) and lubricate with clean hydraulic oil.

(10) Remove rod seal (14) and backup washer (15) from end cap (4).

(11) Remove tube seal (16) from end cap (4).

(12) Remove tube seal (17) from end cap (3).

GO ON TO NEXT PAGE

4-54