Figure 3-37.2. Lift Cylinders, Replacement.

TM55-1730-228-13&P

3-35. LIFT CYLINDERS - REPLACE (Continued)

3-35

Figure 3-37.2. Lift Cylinders, Replacement.

Check pin alignment with a drift through the lock collar before installing roll pins.

(5) Install roll pins (1 and 3).

(6) Put preformed packing (not shown) in position between hold valve (7, Figure 3-37.2) and cylinder (8).

(7) Put hold valve (7) in position on cylinder (8) and install four bolts with washers.

(8) Install elbow and tee fittings (4) on cylinder (8).

(9) Connect hydraulic hoses (1) and (2) and solenoid connectors (3) to the cylinder (8) and hold valve (7) using

the tags for identification.

(10) Lubricate fittings at both ends of cylinder with GAA grease.

(11) Start SPEMS and remove inspection/service brace.

(12) Check hydraulic reservoir and refill if necessary. Refer to para 2-5, PMCS.

(13) Perform operational check for proper function.

END OF TASK

3-91