APPENDIX II. DIRECT AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS

C 3, TM 9-2920-242-35

APPENDIX II

DIRECT AND GENERAL SUPPORT

MAINTENANCE REPAIR PARTS

Section I. INTRODUCTION

Code

Explanation

1. Scope

are not subject to the provisions of AR 380-41.

This appendix lists repair parts required for the

Assigned to items which are NSA design controlled:

P10

performance of direct and general support of the

special tools, test, measuring and diagnostic equip-

Delco-Remy Engine Electrical Starter Assemblies,

ment for COMSEC support, which are accountable

under the provisions of AR 380-41, and which are

Models 1113943, 1113904, and 1113944.

stocked and supplied by the Army COMSEC Logistic

System.

2. General

Repair Parts, Special Tools and Test Equipment which

This Repair Parts List is divided into the follow-

are not procured or stocked, as such, in the supply

ing sections:

system but are to be manufactured at indicated

maintenance levels.

a. Repair Parts - Section II. A list of repair

Assemblies which are not procured or stocked as such,

parts authorized for the performance of mainte-

but are made up of two or more units. Such com-

nance at the direct and general support level in

ponent units carry individual stock numbers and de-

figure and item number sequence.

scriptions, are procured and stocked separately and

b. Special Tools, Test and Support Equipment.

can be assembled to form the required assembly at

Not applicable.

indicated maintenance categories.

Parts and assemblies that are not procured or stocked

c. Federal Stock Number and Reference Number

because the failure rate is normally below that of the

Index - Section III. A list of Federal stock num-

applicable end item of component. The failure of such

bers in ascending numerical sequence followed by

part or assembly should result in retirement of the

a list of reference numbers in ascending alpha-

end item from the supply system.

numeric sequence, cross-referenced to the illus-

Repair Parts which are not procured or stocked. The

requirement for such items will be filled by the next

tration figure number and item number.

higher assembly or component.

Repair Parts, Special Tools, and Test Equipment which

3. Explanation of Columns

are not stocked and have no foreseen mortality. The

The following provides an explanation of columns

indicated maintenance category requiring such repair

in the tabular lists in Sections II and III.

parts will attempt to obtain the parts through canni-

a. Source, Maintenance, and Recoverability

balization or salvage, if not obtainable through can-

nibalization or salvage the item may be requisitioned

Codes (SMR), Column 1:

with exception data, from the end item manager, for

(1) Source code, indicates the selection status

immediate use.

and source for the listed item. Source codes used

Major assemblies that are procured with PEMA funds

are --

for initial issue only as exchange assemblies at DSU

and GSU level. These assemblies will not be stocked

Code

Explanation

above the DS and GS level or returned to depot supply

Repair Parts, Special Tools and Test Equipment supplied

level.

from the GSA/DSA, or Army supply system, and

NOTE

authorized for use at indicated maintenance categories.

Cannibalization or salvage may be used

Repair Parts, Special Tools and Test Equipment which

as a source of supply for any items source

are procured and stocked for insurance purposes

coded above, except those coded X1.

because the combat or military essentiality of the end

item dictates that a minimum quantity be available

(2) Maintenance Code, indicates the lowest

in the supply system.

category of maintenance authorized to install the

Assigned to items which are NSA design controlled:

listed item. The maintenance level codes are-

unique repair parts, special tools, test, measuring and

Code

diagnostic equipment, which are stocked and sup-

Explanation

plied by the Army COMSEC Logistic System and which

Crew or Operator Maintenance