DIRECT LINEAR VALVE REPLACEMENT (Sheet 1 of 6)

TM 9-2835-255-34

DIRECT LINEAR VALVE REPLACEMENT (Sheet 1 of 6)

TOOLS: General mechanic's tool kit: automotive (SC5180-90-N26)

Extension, 3/8-inch drive, 6 inch (Item 8, Appendix D)

Handle, ratchet (Item 9, Appendix D)

Industrial goggles (Item 58, Appendix D)

Maintenance kit, electrical (Item 98, Appendix D)

Muitimeter (Item 49, Appendix D)

Pliers, wire twister (Item 101. Appendix D)

Socket, 3/8-inch drive, 5/32-inch (Item 108, Appendix D)

Socket, 3/8-inch drive, 3/16-inch (llem 109, Appendix D)

Torque wrench, 0-150 lb-in (Item 27, Appendix D)

SUPPLIES:

Bolt, self-locking (Item 146, Appendix E) (4 required)

Direct linear valve (Item 137, Appendix E)

Flatwasher (Item 140, Appendix E) (3 required)

Flatwasher (Item 135, Appendix E) (6 required)

Gasket (Item 143, Appendix E)

Non-electric wire (item 15, Appendix B) (30 inch)

Non-electric wire (Item 50, Appendix B)

Preformed packing (Item 139, Appendix E)

Preformed packing (Item 141, Appendix E) (2 required)

Screw cap, socket (Item 145, Appendix E) (2 required)

Screw, self-locking (Item 138, Appendix E) (3 required)

Screw, self-locking (Item 144, Appendix E) (4 required)

Shortening compound (Item 20, Appendix B)

Tape (Item 30, Appendix B)

Woodblock (Item 32, Appendix B) (2 required)

EQUIPMENT

CONDITION: Electromechanical fuel system removed (TM 20-1)

REMOVAL:

SET ELECTROMECHANICAL FUEL

SYSTEM (1) ON TWO BLOCKS OF WOOD

(2) SO THAT SPLINE (3) WILL NOT BE

DAMAGED.

DISCONNECT BRACKET (4).

a. Cut lockwire and remove screw (5).

b. Loosen screw on champs (6) and swing

bracket (4) to side.

Put screw (5) back in fitting and tighten.

Go on to Sheet 2

7-40 Change 4