 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
NO. 12 BEARING AND SPLINED COUPLING REPLACEMENT (Sheet 5 of 7)
INSTALLATION:
WARNING
Use caution when using arbor press.
Improper tools or tools not properly
aligned may cause injury to personnel or
damage to parts or equipment.
CAUTION
All bearings that are not vacuum packed
must be cleaned to prevent damage to
parts. Work bench and tools shall be
washed down with solvent prior to assem-
bly.
NOTE
If inner race of No. 12 bearing comes
apart during removal or installation, No. 12
bearing shall be replaced.
1. COAT NO. 12 BEARING (1) AND SPLINED COU-
PLING (2) WITH CLEAN LUBRICATING OIL. PRESS
NO. 12 BEARING, THRUST MARK DOWN, ON
SPLINED COUPLING (2).
a.
Place splined coupling (2) in holding fixture (3)
and place on arbor press.
b.
Coat inner race of No. 12 bearing (1) and jour-
nal of splined coupling (2) with clean lubricat-
ing oil, and position No. 12 bearing (1) thrust
mark down, on splined coupling (2).
c.
Using installation and removal tool (4), press
No. 12 bearing (1) on splined coupling (2).
Go on to Sheet 6
5-128
Change 6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals