CUT AND INSTALL NEW GASKET

TM 9-2835-255-34

LOW PRESSURE ROTOR AND HOUSING ASSEMBLY (COMPRESSOR) AND HIGH PRESSURE

AXIAL COMPRItSSOR AND ROTOR CLEANING (Sheet 7 of 21)

NOTE

Do step 12. only if upper half of gasket (1) was

removed.

12. CUT AND INSTALL NEW GASKET (l).

a. Using removed portion of gasket (1),

measure and cut a new gasket to the same

length.

b. Apply shortening compound to new gasket

(1) and install on spacer half (2).

CAUTION

Be careful not to damage gasket (1) when installing

case and stator assembly (3). If seal (1) is damaged,

remove case and stator assembly and repeat step 12.

13. INSTALL HIGH PRESSURE VANE AND

STATOR ASSEMBLY (TOP HALF) (3),

FOUR BOLTS (4), NUTS (5), 12 BOLTS (6),

NEW WASHERS (7), 14 BOLTS (8) AND

NEW NUTS (9). TIGHTEN BOLTS (4) AND

NUTS (5). TORQUE BOLTS (6 BETWEEN

100-110 LB-IN (11-12 Nm). TORQUE

BOLTS (8) BETWEEN 68-75 LB-IN (7-9

Nm).

a. Position high pressure case and stator

assembly (top half) (3) on engine (10).

b. Install two bolts (4) and nuts (5) on both

sides of case and stator assembly (3), at

split line flange (11). Tighten bolts (4) and

nuts (5).

Go on to Sheet 8

5-40 Change 4