INSTALL NEW PACKING - TM-9-2835-255-340412

TM 9-2835-255-34

LOW PRESSURE ROTOR AND HOUSING ASSEMBLY (COMPRESSOR) AND HIGH PRESSURE

AXIAL COMPRESSOR AND ROTOR CLEANING (Sheet 8 of 21)

NOTE

Only 12 of the 16 bolts (1) required are to be in-

stalled at this time. Do not install bolts in third and

fourth holes (2) from split line on both sides of case

and stator assembly (3). They will be installed later

on in this task.

c. Apply antiseize compound to 12 bolts (l).

Install 12 bolts (1) and new Iockwashers

(4). Do not install bolts in third and fourth

holes (2) from split line on both sides of

case and stator assembly (3). Torque bolts

(1) between 100-110 lb-in (ll-12 N m).

d. Install 14 bolts (5) and new nuts (6).

Torque bolts (5) and nuts (6) between

68-75 lb-in (7-9 Nm).

CAUTION

Do not stretch new packing (7) when fitting it in

groove (8).

NOTE

Do step 14. only if packing (7) was removed.

14. INSTALL NEW PACKING (7).

a. Cut packing (7) so it becomes one length.

b. Cut packing (7) to fit in groove (8) so both

ends but against flanges (9)

c. Apply shortening compound to packing (7)

and install in groove (8).

Go on to Sheet 9

Change 4 5-41