 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2815-224-34&P
Engine Block Maintenance Instructions (Cont)
3-4. REAR END PLATE REMOVAL/INSTALLATION (CONT).
(3) Coat gasket (4) with grease and install
over dowel pins (5) onto engine
block (6).
(4) Install end plate (2) on dowel pins (5).
(5) Install four screws (7) and lockwashers (8).
Tighten screws finger tight.
(6) Install screw (9) and lockwasher (10).
Tighten screw finger tight.
NOTE
Special washer is installed in same direction
as noted during removal.
(7') Install special washer (11 ) on screw (12)
with grooved side facing head of screw.
(8) Install dummy hub (13), special
washer (11 ), and screw (12). Tighten screw
finger tight.
(9) Insert two right hand camshaft end
bearings (14) into end plate (2).
Tighten four screws (7) to 35 lb-ft (47 Nm).
(lo)
Tighten screw (9) to 110 lb-ft (149 Nm).
(11)
Tighten screw (12) to 90 lb-ft (122 N-m).
(12)
Remove end bearings (14).
(13)
c. Follow-on Maintenance.
(1) Install camshafts (para 7-9).
(2) Install blower drive support (para 10-2).
(3) Install idler gear (para 7-1 1).
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals