 |
|||
|
|
|||
|
Page Title:
FIGURE 484. INSTALLING CLUTCH COVER ASSEMBLY |
|
||
| ||||||||||
|
|
 (2) Figure 484. (A) Position clutch cover
(2) Check flywheel runout. Figure 482.
assembly against driven member and
(A) Mount dial indicator on engine rear
mounting bracket so indicator point
aline screw holes in clutch cover with
sets on outer flywheel face as shown.
holes in flywheel. (B) Secure clutch
(B) Set indicator on zero reading ("O").
cover assembly to flywheel using eight
3/8-inch lock washers and 3/8 x 15/16
(C) Turn crankshaft assembly 360 de-
grees and check runout. Replace fly-
cap screws. (C) Depress clutch release
levers and remove the four clutch re-
wheel if runout exceeds 0.008-inch TIR.
Recheck runout of new flywheel in the
lease lever spacers. (D) Remove the
same manner.
universal clutch alinement tool.
b. Install Clutch Assembly. Install clutch as-
sembly as follows.
(1) Figure 483. (A) Position clutch driven
member against flywheel with long por-
tion of hub facing out away from fly-
wheel. (B) Install universal clutch aline-
ment tool through hub splines and into
bushing-type pilot bearing in end of
crankshaft. The alinement tool will hold
clutch driven member in position while
installing
cover assembly
clutch
ASSEMBLY.
c. Install Transmission Adapter. Refer to
tions to install transmission adapter. Install
a new transmission adapter gasket between
adapter and flywheel housing.
d. Check Transmission Adapter Runout.
Check transmission adapter runout following
MEMBER USING UNIVERSAL CLUTCH
instructions for figure 162. Runout must be
ALINEMENT TOOL.
within 0.008-inch TIR.
308
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals