 |
|||
|
|
|||
|
Page Title:
FIGURE 46. REMOVING ORINSTALLING TURBOSUPERCHARGE REXHAUSTEL BOW AND SUPPORT (LATE MODEL ENGINES). |
|
||
| ||||||||||
|
|
 (B) Loosen 1-1/4-inch hose clamp se-
Note. Do not disassemble exhaust
curing rubber hose to breather tube
elbow and support (fig. 48) unless re-
adapt er and breather tube. Remove
placement of gasket is necessary.
breather tube.
(3) Figure 46. (A) Remove six 3/8 x 1 cap
.
screw securing turbosupercharger ex-
haust elbow to turbosupercharger tur-
bine housing. (B) Remove three 3/8x
3/4 cap screws and 3/8-inch lock
washers securing turbosupercharger
exhaust elbow support to cylinder and
crankcase. (C) Remove exhaust elbow
andsupport. Remove and discard turbo-
supercharger exhaust elbow inlet gas-
ket.
TURBOSUPERCHARGE REXHAUSTEL BOW
AND SUPORT (LATE MODEL ENGINES).
(4) Figure 47. (A) Remove six 3/8xl cap
screws securing turbosupercharger ex-
haust elbow to turbosupercharger tur-
bine housing. (B) Remove three 3/8x
3/4 cap screws and 3/8-inch lock
washers securing turbosupercharger
exhaust elbow support to cylinder and
crankcase. (C) Remove exhaust elbow
and support as an assembly. Remove
and discard the turbosupercharger ex-
haust elbow inlet gasket. (D) Discon-
FIGURE 48. DISCONNECTING OR CONNECT-
nect the turbosupercharger oil inlet tube
ING TURBOSUPERCHARGER EXHAUST
from 9/16- inch elbow assembly.
ELBOW AND/OR ELBOW SUPPORT.
63
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals