 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
NOTE
All brake adjuster screws do not use Iockwire.
8. CHECK SHOULDERED SHAFT (1).
9. REMOVE ROD END CLEVIS (4)
a. Using micrometer caliper set, measure
AND BRAKE ADJUSTER (5).
diameter (2). Replace shaft (1) if
a. Remove and discard Iockwire (6),
measurement is less than 0.7490 inch
if used, from two screws (7).
(19.025 mm).
b. Using 3/8-inch drive brace handle and
b. Using micrometer caliper set, measure
1/4-inch socket wrench attachment,
diameter (3). Replace shaft (1) if
remove two screws (7).
measurement is less than 0.9990 inch
c. Remove clevis (4) with adjuster (5).
(25.375 mm).
NOTE
Rod end connector (11) has left-hand threads.
10. DISASSEMBLE ROD END CLEVIS (4)
AND ADJUSTER (5).
a. Remove and discard cotter pin (8).
b. Remove pin (9) from clevis (4).
c. Loosen hexagon nut (10) and remove
two rod end connectors (11) and (12)
from adjuster (5).
d. Remove nut (10) from rod end
connector (12).
GO TO NEXT PAGE
4-325
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals