 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
4.
REPAIRER AND HELPER TURN
HOUSING (6) OVER.
REMOVE SERVICE BRAKE
5.
COVER ASSEMBLY (7).
3. REMOVE LEVER ARM (1) FROM
SHOULDERED SHAFT (2), IF
a. Using 3/8-inch drive brace handle
INSTALLED.
and 7/16-inch socket, remove four
screws (8) and washers (9).
a. Remove self-locking nut (3), screw (4),
and flat washer (5).
b. Using plastic-faced hammer, remove
cover (7).
b. Remove lever arm (1) from shaft (2).
7. REMOVE SHOULDERED SHAFT (2).
a.
Using retaining-ring pliers, remove
6. CHECK COVER ASSEMBLY (7).
and discard retaining ring (11).
a.
Using micrometer caliper set and
Remove shim (12).
b.
telescoping gage set, measure inside
Remove pin (13) and slide rod end
c.
diameter of bushing (10). Replace
connector (14) out of shaft (2).
plate (7) if measurement is greater
d.
Remove shaft (2).
than 0.7513 inch (19.083 mm).
4-324
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals