 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
11. CHECK BEARING (1).
a.
Using telescoping gage set and
micrometer caliper set, measure
inside diameter of bearing (1).
If measurement is greater than
b.
3.1498 inches (80.005 mm), go to
step 12.
c.
If measurement is 3.1498 inches
(80.005 mm) or less, go to step 15.
12. IF GEAR (2) WAS NOT REMOVED,
GO TO STEP 13. IF GEAR WAS
REMOVED, GO TO STEP 14.
13. REPAIRER AND HELPER REMOVE
GEAR (2) FROM HOUSING (3).
a. (H) Hold housing (3) on workbench
b. Remove Iockwire (4) from six
screws (5).
c.
Remove six screws (5) and washers (6).
Turn over housing (3).
Using pry bar, evenly pry off gear (2).
d.
4-85
GO TO NEXT PAGE
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals