 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-249-34&P
82 Install turbine assembly (1) onto converter
84 Using a hoist, position converter housing
output shaft splines (2).
assembly (1) on wood blocks, so that it rests on
the rear flange (converter up) Install square seal
ring (2) into the groove in converter pump (3).
Install lockup clutch back plate (4) onto the
converter pump.
83 Using driver kit (1), (8, table 3-11, install
snapring (2) onto the converter output shaft, to
retain the turbine assembly.
8-30
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals