Insert eyebolt - TM-9-2520-249-34-P0175

TM 9-2520-249-34&P

27. Attach lifting sling (1) (25, table 3-1) at top of

25. Insert eyebolt (1), 10, table 3-1) into the end of

output housing (2). Install oil baffle (3) on brake

output shaft (2) and install the output shaft, steer

hub (4). Install two 3/ 8-16 x 4-inch, headless

planetary carrier and brake hub as a unit. The

guide bolts (7), 180 degrees apart, into bevel

splines of brake hub (3) must engage the intern

gear housing (5). Install gasket (6) on bevel

al-splined brake disks at (4). Also sun gear (2,

gear housing.

step 24, above) must engage the steer planetary

pinions in the unit. Remove eyebolt (1).

26. Install two sealrings (7) onto splined sleeve 10

28. Slide output housing assembly (2) onto guide

Install, in succession. splined sleeve (6) plain

bolts (3) and into position against bevel gear

end first, output drive gear (5). lock plate

housing (4).

assembly (3) with pin (8) toward gear (5),

NOTE

lockwasher (2) and bolt (1). holding each part in

Adjust the. hoist carefully and keep the

place with one hand until bolt (1) is engaged in

output housing assembly parallel with the

threads in output shaft (4). Tighten the bolt

bevel gear housing. Rotate output drive

finger tight at this time.

gear (1) while pushing the output housing

assembly into place. The reverse-range sun

8-14