Installation (cont) - TM-55-8145-203-13-P0049

TM 55-8145-203-13&P

NOTE

The process below includes installation of the outside document holder. If only the inside holder is being

installed, the outside holder will still be in place on the door and the process can start with Step 8.

(5) Apply a thin bead of silicone (Item 1, Appendix

F) on the back of the document holder around

each of the four mounting holes.

4 PLACES

(6) Position outside document holder (1) over holes

in doors and insert four bolts (2) with one washer

(3) each through the holders and the door.

(7) Install seven washers (4) over each of the two-

upper bolts on the inside of the door.

(8) Install nine washers (5) over each of the two

lower bolts on the inside of the door.

(9) Position inside document holder (6) over bolts

(2), being careful not to lose washers (4 and 5).

(10) Install four nuts (7) over the bolts on the inside

document holder.

(11) Hold bolt heads with 7/16-inch socket or socket

and torque nuts to a maximum of 2 ft/lbs.

(12) Close both document holders.

(13) Close right-hand door.

Change 1

4-7