Figure 3-77. Cylinder Head, Removal/Installation.

TM 55-1930-208-24

Figure 3-77. Cylinder Head, Removal/Installation.

Installation.

(1)

Refer to figure 3-77 and check that cylinder head and block mating surfaces are clean and free from

any debris.

(2)

Check that piston crowns are free from foreign material.

(3)

Clean out all threaded holes in top of block with thread chaser.

(4)

Install new head gasket (6).

(5)

Use adhesive (item 1, Appendix C) and install new seals (7).

(6)

Connect hoist to lifting brackets.

(7)

Place cylinder head (5) over engine block. Make a final visual inspection to ensure that all gaskets and

seal rings are in position.

(8)

Wipe the bottom of the cylinder head clean and lower to within inch of gaskets.

3-135