Figure 3-21. Governor Drive Assembly, Disassembly/Reassembly.

TM 55-1930-208-24

3-17. GOVERNOR - Continued.

b. Disassembly - Continued.

(7) Refer to figure 3-21 and disassemble the governor drive assembly.

(a) Remove two bearing retaining bolts (1), two lockwashers (2), and two flat washers (3).

(b) Remove two nuts (4), two set-screws (5), and two flat washers (6).

(d) Separate the housing gasket (10) from the housing.

(e) Withdraw driven shaft (11), bearing (12), and sleeve (13) as an assembly from the drive housing.

(f) If inspection of bearings (8 and 12) indicates they should be replaced, rest bearing on bed of arbor

press and press shaft from bearing, using a brass bar between ram of press and shaft.

Figure 3-21. Governor Drive Assembly, Disassembly/Reassembly.

c. Cleaning.

WARNING

Do not breathe cleaning solvent P-D-680 vapors for long periods of time or use solvent near open flames.

To avoid illness, explosion, or fire, only use solvent in well-ventilated areas away from open flames.

(1) Clean the governor parts with cleaning solvent (item 4, Appendix C).

3-46