Special Information - TM-9-6695-258-34P0006

h. Quantity Incorporated in Unit. Indicates the quantity

of the item used in the breakout shown on the

illustration figure, which is prepared for a functional

NOTE

group, subfunctional group, or an assembly. A "V"

Repair parts should not be requisitioned for plug-in boards

appearing in this column in lieu of quantity indicates that

identified in the plug- in board exchange program, except by

no specific quantity is applicable (e.g., shims, spacers,

the depot designated to perform the

repair.

Repair of

etc).

calibration set components, with plug-in board assemblies or

4. Special Information

subassemblies designated as program exchange replacements

with a recover- ability code of L, will be accomplished by

a. Repair parts for components of standards

replacing the plug-in board.

sets which can be identified as existing in the supply

system will be requisitioned through normal supply

c. The plug-in board exchange program functions are

channels from the appropriate supply

commodity

as follows:

manager.

(1) Requisitioning instructions for initial issue plug-

b. Repair parts for components of standards

in boards will be provided since new instrument boards are

sets which cannot be identified as to proper supply source

included in the program.

will be requisitioned from USAMICOM, using routing

identifier B64 and furnishing as a minimum, the following

(2) As a plug-in board covered by the program fails,

as exception data.

a replacement will be requisitioned. Requisitions will be

submitted to Commander, US Army Missile Command, B64,

(1) Component stock

number

the

Redstone Arsenal, AL 35809.

individual end item to be repaired.

(3) Simultaneously with c(2) above, the defective

(2) Component manufacturer's equipment

board being replaced will be shipped by certified mail, return

model number and serial number.

receipt requested, to the following address:

(3) The equipment manufacturer's stock

Transportation Officer

number as listed in the appropriate manual for the

Anniston Army Depot

desired repair part.

M/F Field Service Stock

Anniston, AL 36201

(

4) The repair part reference designation,

circuit reference, circuit symbol schematic designation, or

When requisitioning a replacement board, the turn-in document

reference number as listed in the manufacturer's manual.

number of the replaced board shall be cited on the requisition.

(5) The technical specification of the repair

5. How to Locate Repair Parts

part as contained in the appropriate manufacturer's

manual.

a. When NSN or reference number is unknown:

(6) The title and date of the manufacturer's

(1) First. Using the table of contents, determine the

manual from which the information in paragraphs a, b(3),

assembly

(functional group) within which the repair part

(4), and (5) above was taken.

belongs.