Maintenance Code - TM-9-6695-256-34P0003

TM 9-6695-256-34P

PG - Item procured and stocked to provide for sustained

AH - Item to be assembled at general support

support for the life of the equipment. It is applied

maintenance level.

to an item peculiar to the equipment which,

because of probable discontinuance or

AD - Item to be assembled at depot maintenance level.

shutdown of production facilities, would prove

uneconomical to reproduce at a later time.

XA - Item is not procured or stocked because the

requirements for the item will result in the

KD - An item of a depot overhaul/repair kit and not

replacement of the next higher assembly.

purchased separately. Depot kit defined as a kit

that provides items required at the time of

XB - Item is not procured or stocked. If not available

overhaul or repair.

through salvage, requisition.

KF - An item of a maintenance kit and not purchased

XC - Installation drawing, diagram, instruction sheet,

separately. Maintenance kit defined as a kit that

field service drawing, that is identified by

provides an item that can be replaced at

manufacturer's part number.

organizational or intermediate levels of

maintenance.

XD - A support item that is not stocked. When required,

item will be procured through normal supply

KB - Item included in both a depot overhaul/repair kit

channels.

and a maintenance kit.

NOTE

MO - Item to be manufactured

fabricated

Cannibalization or salvage may be used as a

organizational level.

source of supply for any items coded above

except those coded XA and aircraft support

MF - Item to be manufactured or fabricated at the direct

items as restricted by AR 700-42.

support maintenance level.

(2) Maintenance Code. Maintenance codes

MH - Item to be manufactured or fabricated at the

are assigned to indicate the levels of maintenance

general support maintenance level.

authorized to USE and REPAIR support items. The

maintenance codes are entered in the third and fourth

MD - Item to be manufactured or fabricated at the depot

positions of the Uniform SMR Code format as follows:

maintenance level.

(a) The maintenance code entered in the

AO - Item to be assembled at organizational level.

third position will indicate the lowest maintenance level

authorized to remove, replace, and use the support item.

AF - Item to be assembled

direct

support

The maintenance code entered in the third position will

maintenance level.

indicate one of the following levels of maintenance: