Special Information - TM-9-6695-247-34P0006

h. Quantity Incorporated In Unit. Indicates

NOTE

the quantity of the item used in the breakout

shown

the illustration figure, which is

Repair parts should not be requisitioned

prepared for a functional group, sub-functional

for plug-in boards identified in the plug-in

group, or an assembly. A "V" appearing in this

board exchange program, except by the

column in lieu of quantity indicates that no

depot designated to perform the repair.

specific quantity is applicable (e.g., shims,

Repair of calibration set components,

spacers, etc).

with plug-in board assemblies or

subassemblies desig-nated as program

exchange

replace-ments

with

4. Special Information

recoverability code of L, will be

accomplished by replacing the plug-in

a. Repair parts for components of standards

board.

sets which can be identified as existing in the

supply system will be requisitioned through

The plug-in board exchange program

normal supply channels from the appropriate

functions are as follows:

supply commodity manager.

(1) Requisitioning instructions for initial issue

b. Repair parts for components of standards

plug-in boards will be provided since new instrument

sets which cannot be identified as to proper

boards are included in the program.

supply source will be requisitioned from

USAMICOM, using routing identifier B64 and

(2) As a plug-in board covered by the

furnishing as a minimum, the following as

program fails, a replacement will be requisitioned.

exception data.

Requisitions will be submitted to Commander, US Army

Missile Command, B64, Redstone Arsenal, AL 35809.

(1) Component stock

number

the

individual end item to be repaired.

(3) Simultaneously with c(2) above, the

defective board being replaced will be shipped by

(2) Component manufacturer's equipment

certified mail, return receipt requested, to the following

model number and serial number.

address:

(3) The equipment manufacturer's stock

Transportation Officer

number as listed in the appropriate manual for the

Anniston Army Depot

desired repair part.

M/F Field Service Stock

Anniston, AL 36201

(4) The repair reference designation, circuit

reference, circuit symbol schematic designation, or

When requisitioning a replacement board, the turn-in

reference number as listed in the manufacturer's

document number of the replaced board shall be cited on

manual.

the requisition.

(5) The technical specification of the repair

5. How to Locate Repair Parts

part as contained in the appropriate manufacturer's

manual.

a. When NSN

reference

number

unknown:

(6) The title and date of the manufacturer's

manual from which the information in paragraphs a, b(3),

(1) First.

Using the table of contents,

(4), and (5) above was taken.

determine the assembly (functional group)

within which the repair part belongs.