Part Number - TM-9-4931-479-34P0005

TM 9-4931-479-34P

H-

Reparable item.

When uneconomically

e. Federal Supply Code for Manufacturer

reparable, condemn and dispose at the general

(FSCM). The FSCM is a 5-digit numeric code listed in

support level.

SB 708-42 which is used to identify the manufacturer,

distributor, or Government agency, etc.

D-

Reparable item.

When beyond lower level

repair capability, return to depot. Condemnation

f. Description. Indicates the Federal item name

and disposal not authorized below depot level.

and, if required, a minimum description to identify the

item. The physical security classification of the item is

L-

Reparable item. Repair, condemnation, and

indicated by the parenthetical entry (insert applicable

disposal not authorized below depot/specialized

physical security classification abbreviation, e.g., Phy

repair activity level.

Sec C1 (C) -Confidential, Phy Sec C1 (S) -Secret, Phy

Sec C1 (T) -Top Secret). Items that are included in kits

A-

Item requires special handling or condemnation

and sets are listed below the name of the kit or set with

procedures because of specific reasons (.e.,

the quantity of each item in the kit or set indicated in the

precious metal content, high dollar value, critical

quantity incorporated in unit column. When the part to

material or hazardous material).

Refer to

be used differs between serial numbers of the same

appropriate manuals/directives for specific

model, the effective serial numbers are shown as the

instructions.

last line of the description. In the Special Tools List, the

initial basis of issue (BOI) appears as the last line in the

c. National Stock Number (NSN). Indicates the

entry for each special tool, special Test, Measurement,

NSN assigned to the item and which will be used for

and Diagnostic Equipment (TMDE), and other special

requisitioning.

support equipment.

When density of equipments

supported exceeds density spread indicated in the BOI,

d. Part Number. Indicates the primary number

the total authorization is increased accordingly.

used by the manufacturer (individual, company, firm,

corporation, or Government activity), which controls the

g. Unit of Measure (U/M). Indicates the standard

design and characteristics of the item by means of its

of the basic quantity of the listed item as used in

engineering drawings, specifications, standards, and

performing the actual maintenance function.

This

inspection requirements to identify an item or range of

measure is expressed by a two character alphabetical

items.

abbreviation (e.g., ea, in, pr, etc). When the unit of

measure differs from the unit of issue, the lowest unit of

NOTE

issue that will satisfy the required units of measure will

When a stock numbered item is

be requisitioned.

requisitioned, the item received may

have a different part number than the

part being replaced.