 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 PROCEDURES
3 PLACES
o
2
6
Test Equipment/Special Tools:
. Screwdriver, cross tip, No. 2
Supplies:
NOTE: Expendable supplies are defined in
volume 1, appendix C.
. Bonding (Item 7)
Equipment Conditions:
on clean work surface.
q
on clean work surface.
.
I
.
to
Position
(1) in
so front of
q
is accessible at side of
and rear of
can be connected to
harness.
(3) to
Connect cable connector
q
(4).
receptacle
(5) to
Connect cable connector W
q
(6).
receptacle
Screw in and tighten 3 screws (2) using cross
q
tip screwdriver.
m
J
q
. Ground
. Connect one end of clip lead
to
chassis.
q
. Connect other end of clip lead (7) to bench
ground.
. Set THERMAL MODE switch (8) to OFF.
7
. Set THERMAL TEST switch (9) to OFF.
*
q
q
q
WARNING
The top half of the
contains HIGH VOLTAGE
that can cause serious injury or death. Keep hands
and tools away from this area.
AR
Figure 7-35 (Sheet 1 of 4)
Ill
volume
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals