 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TROUBLESHOOTING PROCEDURES
DISPLAY READS -
1.5.0.2
REFER TO PROCEDURE
READING NOW IS:
Common Tools:
q Alignment tool
WARNING
HIGH
VOLTAGE
is used in the operation of the
ON
CONTACT
May result if you fail to observe safety
precautions:
q DO not reach into
with alignment tool any
farther then necessary.
q Make sure alignment tool does not touch any
except points specified.
thing in
NOTE
During adjustment, message display may
read --
HAS ADJUSTMENT BEEN ATTEMPTED?
you have tried to make the adjustment, press
YES key (1). If you are not finished, press NO key
(2) and try to make adjustment.
Power down
q Set
POWER switch (3) to OFF.
Remove access cover from
q
q Refer to Remove Access Cover;
3-7.
TM 9-1200-206-34-2-2,
Power up
q
q Set
POWER switch (3) to ON.
AR
Figure 7-33 (Sheet 1
of 2)
Volume Ill
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals