 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TROUBLESHOOTING PROCEDURES
q Continue with operator assisted self-test
q Power down test set,
. Set TEST SET POWER switch (1) to OFF.
q Refer to figure 6-2.
q Remove
from
. Refer to volume IV, para. 2-12.
circuit card assembly Al,
q Replace
q Refer to TM 9-1200-206-34-2-2,
para. 3-8.
q Install
into
"
q Refer to volume IV, para. 2-12.
. Power up test set.
. Set TEST SET POWER switch (1) to ON.
q Run operator assisted self-test to the end of
test block 21.
q Refer to figure 6-2.
Does message display read
FAIL CODE 0.0.0.2
q Continue with operator assisted self-test.
q Test set cannot be
at this
I
. Refer to figure
q Turn in test set to next higher level of
maintenance.
Figure 7-2. (Sheet 5
5)
7-9
Volume Ill
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals