REMOVE SEAL RING, BACKPLATE, AND THRUST SPACER

TM 9-2990-206-34&P

DISASSEMBLY--Continued.

TOOLS:

9/16 inch, double offset box wrench

Plastic insert hammer

REMOVAL:

1. Using fingers, remove and discard seal ring (A)

from groove in turbine wheel shaft (B).

2. Using 9/16 inch box wrench, remove four bolts

and flat washers (C) from center housing.

3. Tap the backplate (D) with a plastic insert

hammer and remove it from the center housing

(E).

4. Remove thrust spacer (F) from backplate (D).

5. Us;ing fingers, remove and discard two spacer

rings (G) from thrust spacer (F).

TA097813

3-7