 |
|||
|
|
|||
|
Page Title:
Section II. GENERAL MAINTENANCE |
|
||
| ||||||||||
|
|
 TM 9-2990-206-34&P
Section Il. GENERAL MAINTENANCE
2-3. GENERAL.
2-6. IMPROVISED TOOLS.
Special tools, repair parts, and equip-
The holding fixture shown below
ment over and above those available to
applies only to direct and general sup-
the using organization are supplied to
port units to enable these maintenance
direct and general support units for
organizations to fabricate it locally.
maintaining and repairing the material.
it is of chief value to units engaged
in repairing a large nunber of similar
components. However, it is not
2-4. COMMON TOOLS AND EQUIPMENT.
essential for repair and is not avail-
able for issue.
For authorized common tools and equip-
ment refer to the Modified Table of
Organization and Equipment (MTOE)
applicable to your unit.
2-5. SPECIAL TOOLS.
A thread tap and screw thread inserter
are required for repair of these turbo-
superchargers.
NOTE
Fabricate from hard wood or
aluminum. Drill eleven 0.375 inch
(9.5 mm) holes equally spaced on
the 5.25 inch (133.4 mm) diameter.
Cut out 5.00 inch (127 mm) circle.
Bottom block is solid. Assemble
top and bottom blocks with screws
or bolts.
2-7. REPAIR PARTS.
Repair parts are listed and illustrated
in Appendix B of this manual.
TA07807
2-5/2-6 (blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
