Insert terminal cover

TM 9-2920-258-30&P

Insert terminal cover (40) and pull jumper connector (39) into place against S.R. end

housing (1). Secure in place with two screws (36), two Iockwashers (37), two screws

(38) and two Iockwashers (37).

Align jumper connector (39) and connector assembly (41). Secure in place with four

Iockwashers (35) and four screws (34).

NOTE

Install brush lead away from brush spring.

Insert four brushes (8) partially into brush rigging assembly (31). Install tabbed

Iockwasher (29), two brush leads (8), terminal lead (28), Iockwasher (27) and nut (26)

onto existing stud of brush rigging assembly (31). Close tabbed Iockwasher over nut.

Repeat for opposite side.

Place bearing retainer (25) onto end of S.R. end housing (1). Secure in place with

three screws (24).

3-17