Place end housing

TM 9-2920-257-30&P

NOTE

End housing (11) mounting foot should line up with front housing (12) mounting

foot.

(20.) Place end housing (11) on stator shell (12) and using arbor press (item 7, App D), press end housing onto

stator shell until seated against shell (minimal force is required).

(21.) Install nine new flanged locknuts (10) on stator shell studs. Tighten locknuts to 18 in-lb torque.

CAUTION

Care must be taken when pressing the bearing into the housing. Use caution as

the bearing outer race begins to enter the end housing bore. Misalignment can

damage the end housing.

(22.) Using an arbor press (item 4, App D), press bearing (15) onto core and shaft assembly (4).

Change 1 3-39