 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9-2920-257-30&P
(c) Insert four screws (7) with lock washers (8) through holes in
a n t i - d r i v e end housing (9) and thread them into holes in drive end
h o u s i n g assembly (21).
Tighten screws securely.
(10) Install brush holder, brushes, and printed circuit panel
assembly in drive end housing assembly (fig. 3-3).
Use figure 3-12 as a
guide when making lead connections.
(a) Assemble brush assembly unit (12) as follows:
1.
I n s t a l l two brush assemblies (9) into two holes of brush
h o l d e r (10), with tabs at end of brush springs placed in shallow cavities
of brush holder.
2.
P l a c e brush cover (8) in position on top of brush holder
(10), routing brush leads through holes in brush cover.
(b) Assemble circuit panel assembly unit (11) as follows:
1.
A s s e m b l e four screws (1),
lock washers (2), washers (3), and
insulations washers (4) on top of printed circuit panel assembly (5).
.
2.
Push four screws (1) through printed circuit panel assembly
(5).
P l a c e a spacer (7) on each of the four screws.
(c) Assemble printed circuit panel assembly unit (11) to brush
assembly unit (12).
1.
R o u t e black leads from two brush assemblies (9) through hole
in printed circuit panel assembly (5).
R o u t e four screws (1) from printed circuit panel assembly
2.
unit (11) through four holes in brush assembly unit (12).
3-24
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals