Remove inside seal

TM9-2920-257-30&P

(6) Remove inside seal, outer seal, roller bearing, and slideable

bushing from anti-drive end housing (fig. 3-1).

(a) place anti-drive end housing (9) on workbench. Use a 3/8 inch

p u n c h t o k n o c k o u t i n s i d e s e a l ( 1 0 ) a c c o r d i n g t o f i g u r e 3 - 4 . Discard

seal.

CAUTION

If anti-drive end housing is not flat when placed in arbor

press, it can crack.

Make sure that anti-drive end housing is

placed flat.

Guide pins must not rest on arbor press.

( b ) T u r n a n t i - d r i v e e n d h o u s i n g o v e r , a n d place it in arbor press

according to figure 35.

a c c o r d i n g t o f i g u r e 3 - 5 , a n d press out outer seal (11) and roller bearing

Discard bearing and seal.

( 1 2 ) at the same time.

( d ) Use a 1/2 inch diameter bolt to press out slideable bushing

(13) while supporting housing ear.

(7) Remove rotor (14).

CAUTION

W h e n h a n d l i n g s t a t o r , d o not allow winding end turns to be

p l a c e d on any hard surfaces.

Failure to do this may result in

damage to stator winding end turns.

(a) Place generator in arbor press with drive end housing assembly

and supported on stator (19) housing outer edges.

( 2 1 ) facing

3-8