Remove printed circuit panel assembly

TM 9-2920-257-30&P

(4) Remove printed circuit panel assembly, brush assemblies, and

brush holder (fig. 3-3).

( a ) R e m o v e t h r e e n u t s ( 1 0 , f i g . 3 - 2 ) securing three long black

leads from printed circuit panel assembly (7, fig. 3-2) to three stator

terminal studs.

fig. 3-2) securing short black lead from

( b ) Remove screw (11,

printed circuit panel assembly (7, fig 3-2) to housing ground hole.

insulation washers (4) securing printed circuit panel assembly (5) to

drive end housing (6).

CAUTION

Brush holder can be damaged if not handled carefully.

Handle

brush holder carefully.

(d) Remove printed circuit panel assembly (5), four spacers

( 7 ) , b r u s h c o v e r ( 8 ) , t w o brush assemblies (9), and brush holder

(10) from drive end housing assembly (6).

If brush holder binds to

drive end housing, tap brush holder with plastic mallet.

(5) Remove anti-drive end housing (fig. 3-1).

(a) Remove four screws (7) and lock washers (8) used to

secure anti-drive end housing (9) and stator (19) to drive end

housing assembly (21).

NOTE

If antidrive end housing binds to stator, tap housing with

plastic

mallet.

(b) Remove anti-drive end housing (9) from shaft of rotor (14).

3-6