Disassembly Drive Clutch And Lever Housing Assemblies.

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

DISASSEMBLY OF THE STARTER ASSEMBLY - CONTINUED

0008 00

5. Disassembly Drive Clutch And Lever Housing Assemblies.

a. Remove seven hex head cap screws (1) and lock washers (2) which attach lever housing assembly (3) to

starter frame (4). Discard lockwashers.

b. Use a wood block and hammer to start separation of lever housing (3) from starter frame (4).

Loosen hose clamp (5) and work rubber bellows (6) off solenoid assembly (7) as lever housing assembly (3)

is pulled away from starter frame (4).

WARNING

Hold Bendix drive to prevent injury.

d. Inspect bellows for tears punctures and deterioration. Replace bellows if defective.

e. When solenoid plunger (8) is out of solenoid assembly (7), remove hose clamp (5). Remove preformed

packing (9) from lever housing. Discard packing.

Inspect solenoid plunger for cracks and distortion. Replace plunger if defective.

g. Inspect plunger rod threads. Replace plunger if threads are stripped.

0008 00- 11