Generator Assembly.

TM 9- 2920- 224- 34&P

ASSEMBLY OF THE GENERATOR - CONTINUED

0010 00

5. Generator Assembly.

a. Install dirt and liquid deflector (1) on drive end of armature shaft (2) with shoulder on deflector flaring outward

toward bearing (3).

CAUTION

Use a hammer and an arbor made from a piece of soft

metal, tubular pipe stock to install ball bearing. Tubular

pipe stock must have a bore diameter slightly larger than

that of armature shaft and an outside diameter slightly

larger than that of bearing inner race.

b. Support armature shaft (2) upright with commutator--end of shaft on a soft--wood block. Start annular ball

bearing (3) onto drive end of armature shaft (2). Use arbor (4) to drive bearing inner race (5) onto shaft until

bottomed with deflector (1) against shoulder on shaft.

Install dirt and liquid deflector (1) on drive end of armature shaft (2) with shoulder on deflector flaring outward

away from installed bearing (3).

d. Use snapring pliers to install retaining ring (6) in groove around shaft (2).

0010 00- 13