Slide an electrical contact brush

TM 9- 2920- 224- 34&P

ASSEMBLY OF THE GENERATOR - CONTINUED

0010 00

NOTE

Continuity can be checked with a multimeter on Rx1

scale.

Using needle--nose pliers, slide insulation sleeve (5) back from end of lead and hold while soldering each lead

(16) to its proper capacitor (7).

When soldered connections have cooled, use needle--nose pliers to slide insulation sleeve (5) over soldered

connection at each capacitor (7).

Slide an electrical contact brush (22) into each fan motor brush holder (23). Position one cap (24) to cup

spring disk (25) at outer end of brush spring (26) and carefully compress spring until the cap can be threaded

onto its brush holder.

Install remaining cap (24) as in step k and tighten both caps onto their brush holders (23).

m. Apply sealant to threads of each electrical conduit end seal plug (27). Install these plugs in fan housing (12)

before sealant sets.

0010 00- 8