Assembly-continued - TM-9-2815-224-34-P0466

TM9-2815-224-34&P

Fan Clutch Maintenance Instructions (Cent)

18-2. FAN CLUTCH REPAIR (CONT).

(23) Apply lubricating oil to two springs (18) and install springs,

concave side up, on clutch body (16).

(24) Apply oil to thrust washer (19) and install, flat side up, on

springs (18).

NOTE

Be sure blocking does not touch clutch body.

(25) Support piston housing (17) with suitable blocking.

CAUTION

Do not press thrust washer down more than 1/32-in. (0.8 mm) or

thrust washer and springs may be damaged.

(26) Press thrust washer (19) down 1/32-in. (0.8 mm) using tool

No. 6 and install retaining ring (20) in piston housing (17).

(27) Apply sealing compound to threads of four screws (21).

(28) Install two oilers (22) with four screws (21). Tighten screws to

45 lb-in (5.1 Nm).

(29) Install setscrew (23) but do not tighten.

(30) Install load cell assembly (24) until upper surface of

clutch body (16) is flush with, or just below shoulder

of shaft.

(31) Aline setscrew (23) with oil holes (25) and setscrew

hole (26) on bracket and shaft assembly (4).

CAUTION

Setscrew must rest in center of hole. Make sure setscrew

is centered when tightened or damage to shaft may

result.

(32) Tighten setscrew (23) to 50 lb-in (5.4 Nm).

18-10