Installation. - TM-9-2815-224-34-P0434

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

15-9. THROTTLE CONTROL SOLENOID REMOVAL/INSTALLATION (CONT).

(3) Remove two fittings (4).

(4) Remove solenoid (5).

(5) Remove screw (6), lockwasher (7), and ground

wire (8).

(6) Remove two screws (9) and lockwashers (10) to

separate brackets (11 and 12).

b . Installation.

(1) Install two screws (1) and lockwashers (2) to

brackets (3 and 4).

(2) Install screw (5), lockwasher (6), and ground wire (7).

(3) Slide solenoid (8) in position.

WARNING

Adhesives, solvents, and sealing compounds can burn

easily, can give off harmful vapors, and are harmful to

skin and clothing. To avoid injury or death, keep away

from open fire and use in well-ventilated area. If

adhesive, solvent, or sealing compound gets on skin or

clothing, wash immediately with soap and water.

(4) Apply pipe thread sealing compound on two

fittings (9). Install fittings.

(5) Connect two air lines (10).

(6) Connect two wires (11 and 12).

c. F o l l o w - o n Maintenance.

(1) Connect batteries (TM 9-2320-279-20).

(2) Close air drains (TM 9-2320-279-20).

(3) Start engine and build air pressure to

operating pressure

(TM 9-2320-279-10).

(4) Adjust engine speed control

(para 19-9).

(5) Install front cargo panel (M977 and M985 only) (TM 9-2320-279-10).

END OF TASK

15-34