Installation. - TM-9-2815-224-34-P0422

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

(11) Remove pin (22) from air cylinder (10) and air

cap (23).

(12) Remove retaining ring (24), air cap (23), and

piston (25) from air cylinder (10).

(13) Remove seal ring (26) from piston (25).

WARNING

Adhesives, solvents, and sealing compounds can burn

easily, can give off harmful vapors, and are harmful

to skin and clothing. To avoid injury or death, keep

away from open fire and use in well-ventilated area.

If adhesive, solvent, or sealing compound gets on skin

or clothing, wash immediately with soap and water.

Compressed air used for cleaning purposes will not

exceed 30 psi (207 kPa). Use only with effective

chip guarding and personal protective equipment

(goggles/shield, gloves, etc.).

(14) Clean low speed limiting governor in dry cleaning solvent. Dry parts with compressed air.

b . Installation.

NOTE

All metal parts must be lubricated with grease.

(1) Install seal ring (1) on piston (2).

(2) Install piston (2) and air cap (3) in air cylinder (4).

(3) Install pin (5) flush with edge of air cylinder (4) and

air cap (3).

(4) Install retaining ring (6) on air cylinder (4).

NOTE

Locknut is installed 1-1/2 in. (38,1 mm) on spring retainer. Only for clearance

when installing spring retainer.

(5) Install locknut (7) on spring retainer (8).

(6) Install spring (9) and plunger (10) in spring retainer (8).

(7) Install spring (12), plunger (11), spring (13), and spring cap (14) in plunger (10).

15-24