Cleaning/lnspection.

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cent)

(3) Remove retaining ring (5), two washers (6), and preformed

packing (7).

(4) Remove stop lever shaft (2) and return spring (8) from

governor cover (4).

(5) Remove retaining ring (9), washer (10), copper

washer (11 ), preformed packing (12), and two

bushings (13) from speed control lever shaft (14).

(6) Remove speed control lever shaft (14) from governor

cover (4).

(7') Remove pin (15) from speed control lever shaft (14).

c. C l e a n i n g / l n s p e c t i o n .

WARNING

Adhesives, solvents, and sealing compounds can burn easily,

can give off harmful vapors, and are harmful to skin and

clothing. To avoid injury or death, keep away from open fire

and use in well-ventilated area. If adhesive, solvent, or

sealing compound gets on skin or clothing, wash immediately

with soap and water.

(1) Clean cover assembly (1) with dry cleaning solvent and dry

with clean rag.

(2) Inspect speed control lever shaft (2) and stop lever

shaft (3) for wear or damage. Replace if damaged.

(3) Inspect return spring (4) for cracks, breaks, or damage.

Replace if damaged, cracked, or broken.

(4) Inspect bushings (5) for scoring or out-of-round condition.

If bushings are deeply scored (0.0312 in. (0.79 mm)) or if more than 0.005 in. (0.15 mm)

out-of-round, replace cover.

d. Assembly.

NOTE

Spring arm goes behind stop pin. Spring tang goes over

stop lever shaft.

(1) Install return spring (1) on governor cover (2).

NOTE

Lever end of shaft is positioned against stop pin on side

opposite speed control lever shaft.

(2) Install stop lever shaft (3) in return spring (1) in

governor cover (2).

15-17